Morley

JD-10

Amplifier, Headphone, Amplifier, Pre, Speaker, Audio Interface, Effect

Main Details
Maker Morley Company
Function
Channels/Tracks
  • 1 × Channel
Form Factor Footswitch
Signal Path Analog Hardware
Made In USA
Date Produced 1997
Power Source AC Adaptor Operation - JD10 runs on a regulated adaptor giving a POSITIVE or NEGATIVE output of 9 DC. JD10 is equipped with circuitry that senses the incoming voltages and AUTOMATICALLY adjusts itself internally to the correct polarity. NO HARM CAN BE DONE BY USE OF INCORRECT AC ADAPTORS, providing the above guidelines are adhered to. Battery Operation - JD10 will run on a 9 volt Alkaline battery when an AC adaptor is not convenient. Remove the four outside screws holding the base to the top. The battery connectors will be found inside.
Notes Great at on-the-edge blues to full-on scooped metal, the JD10 2.3 pedal is
a re-created version of the famous direct recording preamp/pedal first
introduced in 1995, but has been specially enhanced for LIVE use into a
typical guitar amplifier.
Named after Jerry Donahue of the Hellecasters, these pedals are truly pro
sounding machines. 110% class in a small package!
The distortion character has grunt and is fizz free just like a low powered
class A or AB1 boutique combo. The blues tone? Think Eric Clapton 'Me
And Mr Johnson' or 'From The Cradle'!! But it's no slouch either. In high
gain modes it can provide that classy big 4x12" tone too!
Just plug JD10 into the input of your guitar amp, like any ordinary stomp
box. It works just like a high class preamp from many upmarket amps. All
the controls operate exceptionally smoothly and have greater that average
range, from jangly cut to full throated bass drive.
The footswitchable TruTone bypass circuit prevents tone losses when in by
pass mode. It will even drive a cable up to 100 metres long without tone
loss! It stops those cheap chorus, flanger and delay pedal from squashing
your guitars tone when they are ALL set in their bypass mode. Thanks
TruTone!
These fab pedals are British Made and have many never seen before
features. The ‘two-tone’ black cases are made from special ‘sand’ grain
and black powder coated 16swg steel, making them exceptionally rugged
and able to withstand the hard life they might get on the road.
AC Adaptor Operation - JD10 runs on a regulated adaptor giving a
POSITIVE or NEGATIVE output of 9 DC. JD10 is equipped with circuitry
that senses the incoming voltages and AUTOMATICALLY adjusts itself
internally to the correct polarity. NO HARM CAN BE DONE BY USE OF
INCORRECT AC ADAPTORS, providing the above guidelines are adhered to.
Battery Operation - JD10 will run on a 9 volt Alkaline battery when an
AC adaptor is not convenient. Remove the four outside screws holding the
base to the top. The battery connectors will be found inside.
Connections
Male XLR Output
Connector: XLR
Input
Connector: 1/4" Phone Jack (6.35mm)
Output
Connector: 1/4" Phone Jack (6.35mm)
Controls
Parameter: Drive Depth
Control Type: Rotary Pot
Parameter: Treble
Control Type: Rotary Pot
Parameter: Middle
Control Type: Rotary Pot
Parameter: Bass
Control Type: Rotary Pot
Parameter: Output Level
Control Type: Rotary Pot
Parameter: Rock Classic
Control Type: Toggle Switch
Parameter: Speaker Simulator
Control Type: Toggle Switch

Comments

Login or Register to post a comment